cmiVFX - Creature Creators Handbook Volume 2 - Part A-B
Time : 7h 13M | Size : 499 MB | Project Files: Included | Software used: Autodesk Maya
با سلام
این آموزش به دنباله قسمت قبلی خود میباشد. به دلیل این که این مبحث بسیار گسترده میباشد، Simon Payne آن را به قسمت های A,B,C,D تقسیم کرده است و در هر قسمت موضوعات خاصی را دنبال میکند.
فعلا 2 قسمت A و B موجود میباشد.
در قسمت A مدرس Simon Payne نگاهی به راه اندازی سیستم IK خواهد داشت و به دنبال آن منوی cmiRigging، ابزارهای UI استاندازد، Advanced Twist و Stretchy Spline را مورد بررسی قرار میدهد.
در قسمت B او نحوه کار با کنترل های globalSRT و halo control را آموزش میدهد و به دنبال آن نحوه scaling کردن سیستم spine، جلوگیری از joint flipping، نحوه راه اندازی بسیار pole vectors به صورت بسیار تمیز و راه اندازی سیستم IK صحبت میکند.
مشاهده توضیحاتــ انگلیسی
Creature Creator's Handbook Volume 2 Part A
cmiVFX presents the second installment of a three volume masterclass series for Creature Rigging and Animation featuring the legendary Simon Payne as our mentor. If you want to become a master at rigging and animation, look no further. Volume 2 Part A of this masterclass takes you right back into the action, showing you in great detail how to work efficiently with Spline IK Setups, the cmiRigging menu, Standard Tools UI, Advanced Twist, and Stretchy Spline. This is top-notch instruction that simply can't be found anywhere else, and Simon Payne's teaching methods are absolutely fantastic. This is rigging and animation at it's finest. NOTE: If you're new to this course, you'll need to watch volume 1 before beginning volume 2. Due to the large amount of information covered in volume 2 of this course, it has been split into five parts labeled A, B, C, D and E. You'll need to watch the entire course to fully understand this material. So, if you're all caught up on the previous material, enjoy Creature Creator's Handbook Volume 2 Part A!
Creature Creator's Handbook Volume 2 Part B
cmiVFX brings you part B of volume 2 for the Creature Rigging and Animation Masterclass featuring Simon Payne. Get ready to pick up right where we left off! Volume 2 part B of this masterclass shows you how to work efficiently with special controls like globalSRT and the halo control. You'll also learn about scaling the spine systems, how to avoid joint flipping, how to set up pole vectors cleanly, and finger I/K setups. This is top-notch instruction that simply can't be found anywhere else, and Simon Payne's teaching methods are absolutely fantastic. This is rigging and animation at it's finest. NOTE: If you're new to this course, you'll need to watch volume 1 as well as volume 2 part A before beginning volume 2 part B. Due to the large amount of information covered in volume 2 of this course, it has been split into five parts labeled A, B, C, D and E. You'll need to watch the entire course to fully understand this material. So if you're all caught up on the previous material, enjoy Creature Creator's Handbook Volume 2 Part B.